With the progress of society from time to time, innovation from time to time. In addition, the lack of talents has caused many enterprises to face some human and talent problems, which has led to obstacles to the operation of the company and the difficulty of consumption has been greatly increased. With regard to the selection of talents and labor, we gradually completed intelligence and replaced the Hot Air Stenter with labor. Some original pipelines are gradually changed to full automation that does not require people.

    This is also true in our screen printing industry, so it is necessary for fully automatic screen printing equipment to be included in improved and innovative solutions. It is very necessary. Only in this way can the machine replace the labor. Does not affect consumption management, does not affect the company's operation.

    Whether it is a flat product, or a curved surface printed product. It has all been mechanized. The Open Type Rotary Screen Printer always has various problems in the printing process, such as manual, semi-automatic all do not operate, the power light is on, and the printing base does not move after moving left, etc. In the semi-automatic mode, the foot switch is not pressed, but it immediately acts. This kind of fault is mostly caused by the damage of the foot switch or the short circuit of the foot switch socket causing a short circuit, and the other is the problem of the manual start button switch. The repair method is to replace the new switch, socket, button switch or dismantle and repair the damaged parts.

    When working in semi-automatic operation, the foot switch slides down and then rises after being released. This phenomenon is usually caused by the proximity switch on the left side of the slide seat being damaged or disconnected. The solution is to change the proximity switch or connect the switch. When working in semi-automatic operation, the vertical slide of the foot switch is lowered, and the printing base does not move after moving to the left. This problem occurs because the proximity switch on the left side of the horizontal slide is not sensed or is defective. The solution is to adjust the induction point of the left proximity switch or change the proximity switch; there is also a micro switch in the foot switch stuck and does not move, which can also cause this problem. The solution is to adjust, repair or replace the micro switch in the foot switch.