(1) Manual Butt Fusion Welding Cleaning Countertop Low Level Echo Cutter, according to the length of the material, the length of the table can be determined. When dealing with long bars, someone should come out to help and follow the operator's order, no push-pull.

(2) Before starting, you must check that the tool should be free of cracks, head bolts, and firmly protected. Then turn the pulley by hand, check the meshing clearance of the gears, and adjust the blade clearance.

(3) In the last idling operation, check the normal operation of transmission parts and bearings.

(4) The machine has not reached the normal speed when not cutting. The middle and bottom halves of the cutter must be used to cut off, to take a quick turn into the steel at the edge, the operator should stand side by side stamping the steel fixed blade, which should prevent the bar from popping out at the end of the cut. There are no points on the sides of the blade to hold the rebar with both hands bent over to feed.

(5) Reinforced and hot steel bars whose shear strength exceeds that specified on the mechanical nameplate. Once cut at the bar, the total cross-sectional area should be within the specified range.

(6) When you should replace the cutting tool for cutting low alloy steel and high hardness, the cutting regulations should follow the mechanical nameplate.

(7) The distance between the blade and the blade should be kept more than 150mm when cutting short, if the holding end is less than 400mm, the barrel or pressed steel short end or trim.

(8) The operation is prohibited directly by the nearby breakage and debris elimination hand, steel swing around and near the non-operator edge impossible to stay in the city.

(9) If the machine cannot run normally, if there is abnormal noise or when the knife is inclined during operation, it should be stopped immediately for inspection. Repair and maintenance must be turned off and the power supply is cut off.

(10) - The operation of the hydraulic cutting machine should check and ensure that the rotation direction of the motor and the level of hydraulic oil meet the requirements. Once activated, the no-load running loose valve opens, expelling air from the hydraulic cylinder, which can be boosted.

(11) Before using the manual hydraulic cutting machine, the drain valve should be tightened clockwise, and after cutting, it should now be unscrewed counterclockwise. To operate, hands should be held steady and cutting machine and insulating gloves should be worn.

(12) After power off after operation, the cutter and the clutter elimination machine are cleaned and lubricated with a wire brush.

Manual Butt Fusion Welding https://www.dowelding.com/Manual-Butt-Fusion-Welding