When the industrial thread twining machine is produced, what matters should be paid attention to? As a manufacturer of glass fiber industrial thread twining machine, let us know what problems should be paid attention to in the production process of industrial thread twining machine!

1. Wear caused by long-term use of the main motor gearbox. This can make the speed of the fixed speed wheel of wire drawing not match with the traction speed and take-up speed, thus forming the single wire drawing.

2. Unstable tension on the reel. There may be many places where air pressure is used in the production workshop, which will cause the air pressure of the industrial thread twisting machine air pump to increase and decrease, which also makes the tension of the wire accumulator not constant, and because the speed of wire take-up is constant, which makes the tension on the wire drawing not constant, which can cause the deviation of the outer diameter of the monofilament not to be accurately controlled

3. Chatter of copper wire on annealing wheel. This allows the copper wire to be annealed when it is loose and tight. The annealing current density is large and small, while the strength of the copper wire is relatively low at a higher speed. Therefore, it is easy to cause the copper wire to ignite on the annealing wheel, which makes the wire diameter on the surface of the copper wire uneven due to the role of sparks.

Solution: The wire accumulator shall be well lubricated to avoid the reverse friction force on the wire when it is running at high speed, which will lead to wire thinning; Adjust the tension of the wire so that the wire drawing stroke is always close to the annealing wheel; Ensure the steel ring of the annealing wheel is in good condition to avoid unstable annealing current due to surface defects of the steel ring.

industrial thread twisting machine https://www.newheli.com/Do-you-know-the-key-points-of-twisting-machine-operation.html